![]() serverpassword – you can put your server password here.welcometext – this will be the text that is displayed upon connection to the server, remember to put the text in quotes.Unless you want it to be elsewhere, leave the default logfile – this will be your default log file location.There are a few parameters that you should change In order to use those parameters, you have to remove that character. Note! By default, some values have a semicolon ( ) at the start of the line. In order to modify it, run the following command sudo nano /etc/mumble-server.iniĬaution! Do not change values if you are unsure of what they do! Mumble provides a configuration file to tweak your server settings. Type in a password that will be used for your administrative account on the server. If not started with root privileges, client will not be able to access your LetsEncrypt certificate in the default folder! SuperUser password If you want your server to prioritize Mumble service to allow for better connection, answer Yes.Ĭaution! If you want to use your own SSL certificate for encryption, you have to use high priority, as Mumble is then started with root privileges. Otherwise the server can be started with the following command sudo service mumble-server start Network priority If you want to start Mumble server after the machine boots up, answer Yes. This will bring up a short configuration, if at any point you want to change settings, you can run the command again. Run the following command sudo dpkg-reconfigure mumble-server By default, Mumble uses a self-signed certificate, there is no password and all data in config file has default values.įirst, you need to change a few settings and setup the SuperUser password for admin access on your server by reconfiguring mumble-server package
0 Comments
Leave a Reply. |